Jump to content

db7512

Members
  • Content Count

    11
  • Joined

  • Last visited

Posts posted by db7512


  1. On 4/13/2017 at 10:04 AM, jbrunson said:

    Brett,

    how many thousandths out of round would be un acceptable? guess I need to drag out my dial guage....

    Incidentally, I just came into possession of a FLIR camera, I plan on doing the turbo bearing cooling study we spoke of in Columbus, Ga.

     

    john

    If you can find a dealer that can do "Forced Balancing" they can also check run out at the same time. The Wing Foot tire shop at a truck stop did not find my problem they just did the standard balance and said everything was fine. I had to drive another 90 miles to a Ford dealer that took care of large trucks. They are the ones that used the forced balance and found the out of round and run out problems with the rims and tires. If needed I can call and find out more about the machine manufacturer who could tell you who in your area that has the proper equipment. My tires/rims looked like eggs being balanced.

     

     

     


  2. May not be your problem but I had a vibration problem that was due to four rims out of round which caused the tires to be damaged. Replaced rims and tires under new vehicle warranty. The Ford dealer (large truck dealer) that found this problem by force balancing tires and rims. Went to two other repair facilities before the Ford dealer who could not find the problem. Good luck.

     


  3. Have you had your front end aligned? My 2016 Georgetown was way out. This helped a lot but I still was not happy and installed a Roadmaster steering stabilizer which helped so more. I have not had a lot of miles on the stabilizer but so far I think it was worth it.

    Does your MH drift or pull a little to one side and then you are correcting continuously? If so do a alignment before adding anything.

×
×
  • Create New...