Jump to content

bobanderson294

Members
  • Content Count

    14
  • Joined

  • Last visited

Profile Information

  • Location
    Dunedin, FL

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Anyone have a recommendation for a Workhorse service shop near the Clearwater, FL area? I generally do all oil and filter changes myself, but would like to find a qualified and competent shop to do pm and repairs as needed. Thanks, Bob Anderson 2004 Fleetwood Southwind 32V Workhorse Chassis w/vortec 8100
  2. Thanks, I'll be sure to follow your advice! Also, thanks for the video link!
  3. I'm wondering how often should the roof of my class A be inspected and new chaulking be applied? I live in southern Florida and the MH is stored without cover.
  4. Thanks, you make a good point about the noise. I may just keep the dash fans for spares and go with the one suggested.
  5. Thanks Herman, The Bergstrom fans I have are two speed, however they do not come with a switch so I purchased a couple of 3-position switches at local Auto parts supplier.
  6. Thanks Rich, but I already have the fans. They are both 7" / 2-speed Bergstroms (same fans as my two factory installed dash fans).
  7. Thanks, good suggestions! I'll check both fuse requirements and wire gauge!
  8. I would like to install (2) Bergstrom dash fans at headboard in bedroom and wondering if I can utilize the power feed that is going to the 12v headboard lamps? Also, would anyone know of a good source for acquiring 2-speed switches for the fans? Thanks
  9. Thanks guys! I've done this in the past but wasn't very comfortable about it. From now on I'll just run the MH Generator if I need the AC while at my house.
  10. Can I connect my MH 30amp main cord with an adapter to a 20amp home outlet and run my AC units without doing harm to the units or my MH electrical system?
  11. Thanks for the suggestions. I was able to get the service manual downloads from Workhorse/Navistar!
  12. I have a 2004 Fleetwood Southwind 32V on a workhorse chassis W22. The 4 way flasher switch located on the steering column needs to be replaced and My question is do I need to remove the steering wheel or can the plastic column covers be removed without removing the steering wheel? Also, where could I purchase a new switch and does anyone know where I might be able to get a workhorse service manual for my unit? Thanks, Bob Anderson
×
×
  • Create New...