F410741 Report post Posted January 26, 2018 I pull 26' stacker with equalizer hitch and switch to flat tow a Jeep with 8" riser. Have tried many ways to tighten up the system. Has anyone figured it out??? Share this post Link to post Share on other sites
philc Report post Posted January 26, 2018 Try this out works great for me http://roadmasterinc.com/products/accessories/hitch/quiet.html Share this post Link to post Share on other sites
F410741 Report post Posted January 26, 2018 Thank you. Share this post Link to post Share on other sites
manholt Report post Posted January 26, 2018 F410xxx. When you say 8" riser! What are you referring to? My jeep is 3" and has 35 x 12.50 x R18...your question is confusing. Share this post Link to post Share on other sites
kaypsmith Report post Posted January 26, 2018 Carl, he is referring to the hitch, ball mount, it is used to level the trailer tongue in his case, or tow bar if he were towing 4 down. It is used to make the ball 8" higher than the receiver, or could be reversed in case the receiver is too high on the coach. F41074, etrailer has one also for price comparison, they do work very well. https://www.etrailer.com/Hitch-Anti-Rattle/Roadmaster/RM-062.html Share this post Link to post Share on other sites
wayne77590 Report post Posted January 26, 2018 I used the Demco Silent Hitch Pin for 9 years on my 2008 Winni. I'm about to get one for the 2015 although I don't hear a rattle back there. It may not be in stock at Amazon but Demco shold have it. Part # is 5846. Share this post Link to post Share on other sites
manholt Report post Posted January 26, 2018 Since I have a fabricated reverse L that my Roadmaster fits in, I have no slack back there and my bar is level. The L bracket is good for 12,000 pounds at the apexes, so I'm not concerned about my Jeep wanting to mate with my Engine in a panic stop! I sold both my 26' and 30' Featherlight Staker's in 2014. Been there! Share this post Link to post Share on other sites
campcop Report post Posted January 30, 2018 Blue Ox makes one that clamps both sides of the bar, a bit $$ but it works very well. Share this post Link to post Share on other sites
super8mm Report post Posted February 1, 2018 Just wondering if you might be using a 2" bar in a 2 1/2" receiver? I have a 2 1/2 receiver on my truck and I have a sleeve that slides in before I put one of my 2" ball hitches in and pin it. Share this post Link to post Share on other sites