desertdeals69 Report post Posted March 14, 2018 How do you shift into neutral with the push button 2/4 wheel drive which is on the dash? I read the manual and it says for RV towing shift transfer case into neutral and put it in park. Share this post Link to post Share on other sites
hermanmullins Report post Posted March 14, 2018 Bruce, Set the Parking brake, start the engine, put the vehicle in neutral, put your foot on the brake pedal and then hold the 2 and 4H buttons down at the same time. It can take up to 15 seconds and the Red neutral light will come on. I would always then put it in drive and release the brake. I would then race the engine to make sure the vehicle is in neutral. Then put the transmission in Park, turn off the engine, release the Parking Brake, remove the key and lock the doors. If I am not mistaken the 01 doesn't have a steering wheel locking pin. Of course this is with the understanding that you have the vehicle hooked up to the RV. Herman Share this post Link to post Share on other sites
manholt Report post Posted March 14, 2018 I had a 2001, Toyota Tundra 4x4, same sequence as the Silverado! I know, Toyota? Silverado? Same engine & transmission! Share this post Link to post Share on other sites
desertdeals69 Report post Posted March 14, 2018 Thanks guys, I will give it a try. Share this post Link to post Share on other sites
desertdeals69 Report post Posted March 14, 2018 Herman, I tried it and it didn't work so I pushed the 2 and 4L and the neutral light came on and was in neutral. Thanks for your assistance. Share this post Link to post Share on other sites
hermanmullins Report post Posted March 14, 2018 Sorry Bruce, I forgot. Been 3 vehicles (all Chevrolets) since I had the push buttons. Glad it worked out. Herman Share this post Link to post Share on other sites
desertdeals69 Report post Posted March 14, 2018 Apology accepted Thanks, Bruce Share this post Link to post Share on other sites
