Jump to content
jraffler

Kwikee Entry Steps

Recommended Posts

Hi all,

Have 2003 Fleetwood Southwind R35 on Workhorse chassis. Entry steps are stuck in up position. Checked fuses in engine compartment, both are good. Followed troubleshooting flowchart from Lippert for the Kwikee steps, however no luck so far.

Any one out there who may have some insights ??? :>) Any assistance is greatly appreciated. Cheers,

Entry Steps up position.jpeg

Share this post


Link to post
Share on other sites

Have you sprayed  some oil on all the pivot points? If they are hung up the current limiter circuity will stop any motion. I have had the best luck with a good bicycle chain oil. 

To get all of them one needs to get under the coach, But make sure you are clear of the area under the steps. They will pin you to the ground ! if they start to move. Not a good location if you are working alone.

Rich.

Share this post


Link to post
Share on other sites

Welcome to the FMCA discussion forums!

Have your steps ever been hit or bent? Those may cause high current draw.

 I agree with Rich, Kwikee recommends monthly lubrication.

Share this post


Link to post
Share on other sites

Have You been in rainy Weather? if so, take wire connector apart + and dry out ,then apply Dielectric Grease to therminals +around Plug to keep Moister out . Good Luck

Old Marine

Share this post


Link to post
Share on other sites

After you oil it, using a rubber mallet or hammer tap the motor, just make sure NO PART OF YOU IS UNDER STEP!!! 

Share this post


Link to post
Share on other sites
3 hours ago, manholt said:

After you oil it, using a rubber mallet or hammer tap the motor, just make sure NO PART OF YOU IS UNDER STEP!!! 

Some years ago I read of a man losing a finger in his steps.

Share this post


Link to post
Share on other sites
10 hours ago, oldmarine said:

Have You been in rainy Weather? if so, take wire connector apart + and dry out ,then apply Dielectric Grease to therminals +around Plug to keep Moister out . Good Luck

Old Marine

Run to Lowe's and get some LIquid Tape. After cleaning the connectors and after getting the steps working use the liquid tape to seal the contacts. It applies with the applicator brush that comes with the can.  Great stuff.

There are several reasons why your steps are not working. Jammed, broken tooth on step pawl, broken tooth inside step motor, bad step motor, low or no voltage, broken ground wire from motor to chassis ground and usually a separate wire than being in the harness.   So many possibility.  Start trouble shooting and call Lippert Customer Support.

Share this post


Link to post
Share on other sites

Even if everything is perfect with the step...It can lock in out or in position, by not allowing it to come fully out and lock, before putting weight on it.  You or a 20 pound dog can do it.

Share this post


Link to post
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now

×
×
  • Create New...