Jump to content
Sign in to follow this  

Generator problem

Recommended Posts

I have a Generac generator in my motorhome. It would stop after 10 minutes but would start right back up and run for about 10 minutes, then stop again. I pulled the ground wire off the oil safety switch but still encountered the same problem.

In checking the wiring, I discovered that both the oil and temp switchs were on the same hot wire. I disconnected the hot wire, and the generator ran for an hour with and without a load until I shut it down. Is there a way to check either switch to find the bad one? Or should I replace both and hope this was the real problem.

Any comments are welcomed. I don't want to use the generator without the proper equipment. Thanks, Coutch.

Share this post

Link to post
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in

Sign In Now
Sign in to follow this  

  • Create New...