Jump to content
Sign in to follow this  
manholt

Electric Macerator Toilet - Tank Sensor

Recommended Posts

My fuse is good, but the toilet thinks that the black tank is full and it's actually empty! I suspect something is blocking the sensor.

My question is: Can I use the San i Flush system to fill tank with water?

I normally just use it long enough to get clear water return.

Carl

Share this post


Link to post
Share on other sites

Problem solved. I used San I Flush for 15 minutes & put in 1/4 tank of water, then pulled knife switch! Hooray, I can flush! :D:):wub:

Now, I also know why my tank always was clear, the black/gray switch is reversed!!! :angry:<_<

Carl

Share this post


Link to post
Share on other sites

FYI...Even if the sensor says the tank is full, you can override it by pushing and holding either flush switch for six seconds. Then it will flush.

Share this post


Link to post
Share on other sites

Bert.

Thank you. I will remember to do that before checking fuse! My fuse and controller is under the drawer, below my dishwasher, a pain to get too!

Carl

Share this post


Link to post
Share on other sites

Same problem again! Six, ten and fifteen seconds, did not work! I hate to think it might be the board or controller... :(

I can survive without a lot off things! But....

Carl

Share this post


Link to post
Share on other sites

Try pushing both switches together...that's how the water level is set, but it flushes first. If it works, take your fingers off the two swithches when the water reaches the desired height in the bowl.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
Sign in to follow this  

×
×
  • Create New...