TonyGA

Hi Brett, All the other stuff that works with the ignition on is working fine. The only thing that I notice that is not working is the cigarette lighting, but that use to work without the key on. I also check a fuse right at one the battery close to the terminal that powers the trans module according to some other info I research on the web. thank Tony

Thanks. I will check those websites....

Hi Wolfe10, I went to work on my Dynasty Monaco 1994. I had the motor running for about an hour. When I started to see the the TWO N's to blink, it took another 10 minutes for the N,s to stop blinking. At that point I accessed the test mode and was able to pull 2 codes: D1 69 32 d2 35 00 The first one i did not find anywhere on the Allison website. Tthe second one came out to be power interruption. Then after that the do not shift trans light came on and I was not able to get off the test mode, I went ahead and checked the charging system alternator regulator clean battery post n it looks like everything is working fine. Today I went and started the engine, hoping that it will get to that point that will let me shift but this time the pad never blink or did any thing. Are there two modules on this RV? Is the shifter pad part of ECM you point out to check connections at the ECM? Also do you know where the ECM is located? Help help help !!!!!

Hi everyone, I was searching the web for some info, on the do not shift light on my 1994 Monaco RV and got into this page, I have the the same problem, the light comes on and stays on, the trans pad is off is nothing there no lights, but after 20 t0 30 minutes the display starts to blink. The N blinks for about 5 minutes and stops at that point I can shift normally. I have driven at least 1200 miles. but every time I stop it will go thru the same thing warm up for about 30 minutes. Ihave not notice any changes and how the trans is shifting. I wast thinking maybe that was a problem with some trans sensor that keep the trans from shifting until the trans oil got hot, but after reading the posts, I am lost. I am going to access the codes. I just found some help on how to do it on the web, if any body can help with this or had have problems like this your help will appreciated.