Jump to content

jerryi

Members
 View Profile  See their activity

  • Content Count

    5

  • Joined

  • Last visited

Posts posted by jerryi

  1. Posted · Report reply

    I wanted to let you all know that I got the front AC working, after retrying several of the things above, mainly-turning off all power including the breakers and doing a reset then trying with the generator the front unit is running-This is great!!  I did go on the roof but there are 14 rusty screws-I'll let my husband take the shroud off when I get home :).  So I"m happy with the one A/C unit.  At least I know that it isn't the dometic thermostat and that it is likely a connection at the A/C unit.

    Again-thanks

  2. Posted · Report reply

    First, I want to thank all of you for your help/suggestions.  I tried a total power off system (including house batteries) with breakers and fuses out for 20 min and that did not do anything-except the controller was not showing an error all the time on zone 1-however nothing responded regardless (putting in fan mode didn't respond).  This am I tried the reset, and that did not work, in fact it is showing a zone 4 only and nothing else-so I am assuming it is a bad controller.  Are these known for going bad?  This unit is just over 3 years old.  Luckily the weather is not really requiring heat/cold, so I will wait till I get home next week to replace.

    Again Thanks.

     

  3. Posted · Report reply

    Just tried the breakers, it looked like it worked momentarily.  Zone 1 did not show and error and only zone 2 showed the error.  So I turned to fan on low on zone 1, and it comes on and then shuts down again.  I'm a little tentative about doing a reset as mentioned above since I did not change anything that would call for a reset.  Is this still something I should try?

  5. Posted · Report reply

    I have two AC units on my Class A Newmar Baystar.  I left the MH with the AC on and when I returned it was off.  There is an E1 code with the zone 2 flashing.  Research has indicated that this means the zone 2 AC unit is not communicating with the Dometic controller and thus neither will operate.  I've tried powering off and on, including shore power.  Should I climb on top of the MH and look to see if there is a loose connection at the AC unit?  If so, do I need to remove the AC cover and is that easy?  Is there any special precautions I need to take.  Thanks-I'm just looking if there is an easy potential solution.

    Kimm

×
×
  • Create New...