Search the Community

My problem has now occurred twice, so I am hoping/expecting that others with a 32 foot Adventurer or Suncruiser, with a full wall slide out, have experienced the same problem. My problem is that the two adjustment bolts that hold the bracket for the roller on the middle slide out ram have broken. These bolt are not accessible without removing the slide out and some of the flooring. The first time they broke I was told that they did so because we did not use the slide out lock while traveling. This was true because during the walk through, when we took delivery of the unit, I specifically asked what was the slide out lock for and was told that it is there “to keep kids from playing with the slide outs”. So, since it had now become “our fault” we ponied up several thousand dollars and had the bolts replaced. But I was then concerned that the real problem was that it was not adjusted correctly. So after the repair I took it to a different repair shop (Winnebago certified) and asked them to check the alignment. For $140 they told me that it was “dead on”. 17 months later the bolts have snapped again. So I am pretty sure it’s a design flaw, but Winnebago will not admit it. So this time I want to repair it myself. My idea is to get the bracket in the right position and then weld a plate between the roller bracket and the bracket that holds the heads of the broken bolts. This can all be done without removing the slide. Of course the down side is that, after that, no more adjustment is possible. My thinking is that it should not have to be adjusted again and even if it did, I can incur the expense of removing the slide out then. The one hitch in the plan is Winnebago will not tell me how to adjust the roller brackets. The only provide information on how to make adjustments at the end of the rams where the slide out connects. I can move the middle bracket to be in the same plane as the two end brackets, but that presumes that both of the end brackets are in the correct location. There is a much longer story that strongly suggests that these bolt broke when the unit was driven from the factory to the dealer, so I have reason to suspect the end brackets are not in the correct location. Has anybody experienced the same problem? Any suggestions? PS It is very hard to detect this problem. Its first symptom is that the slide out is too low to open the outside compartments, However when the slide is out and you inspect the bolts they are jammed so close that the break cannot be seen. If you take it to the dealer they can make adjustments to the outside of the end rams so that the compartments will open. But the problem, will reappear. I found the problem only after I decided to make the adjustment myself and noticed that the dealer had snapped off the head of one of the bolts that attached the slide out to ram. I decided to try to remove that bolt so it can be replaced. So I cribbed the slide out, and imaging my surprised when the ram that was supposed to be support the slide out fell down after I removed that last bolt holding it to the slide out. Yes the slide out was holding up the ram that was supposed to be supporting the slide out. The two broken bolts were then easy to spot. So if any of you have experienced not being able to open your outside compartments and you think it got fixed you may want to have those bolts examined.