Polmex
-
Content Count
24 -
Joined
-
Last visited
Posts posted by Polmex
-
-
Generac makes guardian
-
Hello,
Has anyone here replaced the starter on the guardian quiet pac 75 d generator without removing generator from rv?
-
Thank you for your help. I think whatnis confusing is Instead of a battery bank where they are all together like your diagram, I have 3 on each side of generator and cant see the cables clearly with all the isulation aroundnthosecables. So, I made a diagram and will connect new batteries just like I see these. Thank you again for your response. Have. A great one.
-
Hello, I have a 2005 Alfa see ya. Batteries are bad and need to?replace. Im gonna do it myself. I have 6 6 volt batteries in series. I created a diagram to know how to reconnect when I get new batteries. Also want to add solar charger when done. cabling is confusion. Which is main negative and main positive? 3 on each side of generator but cant see all cable. Any help would he apreciated. Thanks
-
Mainly a deterant is good enough. Not boondocking. Always in a pretty safe area. People that see the camera usually will be better behaved
-
Yes. We performed a full level 3 service . All is good now.
-
Hello; I am considering buying a security camera for my class A. I have read that the ring doorbell camera is pretty good. Can anyone tell me their opinion on if that is the best recommendation or should I keep looking?
-
On 6/26/2022 at 3:56 PM, Polmex said:Thank you for the responses. I tried but could not get entjre side off and dont have room to get un there. Im gonna take it to our shop and have other gen techs help me. Were gonna pull it out and do a complete level 3 service on it. Thanks again
Problem solved. Ended up removing generator from rv. Did complete belt and hose change as well as well as thermostat and complete service. Reinstalled. Tested. All ok now. Thanks for all the suggestions.
-
Can anybody tell me where to get a service manual for my 2005 alfa see ya?
-
Has anybody taken out to perform repairs or full service on it?
-
Thank you for the responses. I tried but could not get entjre side off and dont have room to get un there. Im gonna take it to our shop and have other gen techs help me. Were gonna pull it out and do a complete level 3 service on it. Thanks again
-
Gonna change belt on my generac 7500 watt on my 2005 Alfa founder. Unit does not slide out. Any helpful hints would be apreciated regarding access.etc
-
It was the light fixture after all. Fuses good,wiring good. Thanks for the help. Led light fixture
-
I will check for fuses. Thanks
-
It has led lights that look like circuit boards. I changed them with another fixture and they work
-
Can anyone tell me if interior lights on my alfa founder are controlled by fuses. My bathroom lite does not work. Led lights are good but light will not come on. All other lights work though?
-
Thanks. Im looking for 4wd automatic. Rv has hitch and tow bar already. Dont know if tow bar is ok to use for jeep when I get it. I will have to check into it.
-
Im considering buying a jeep wrangler to flat tow behind my 2005 alfa .any recommendations on. Models to get or stay away from? Also,what do I need to get for towing. My alfa already has a hitch.
-
Kirkland toilet paper says its safe for rv. Is that true ?
-
17 hours ago, rossboyer said:So, is the problem that the top doesn’t fit between the seaty to make the bed? Another post stated that the top should fit on cleats If the cleats are missing orneed to be extended, buy enough 1x2 pine at a big box store. Cut to length and screw it to the seats allowing for the top to drop level.
The table fits on cleats. Only problem is past owners never wanted it as additional sleeping area. So I need to put hinge on wall that connects to table and put new one or two legs on end with folding hinges. I tried Rockler but no luck. Found on amazon that look correct.
17 hours ago, rossboyer said:So, is the problem that the top doesn’t fit between the seaty to make the bed? Another post stated that the top should fit on cleats If the cleats are missing orneed to be extended, buy enough 1x2 pine at a big box store. Cut to length and screw it to the seats allowing for the top to drop level.
-
2 hours ago, hermanmullins said:Welcome to the Forum.
I am sure you might be better off making the part you need. If you could attach a picture of what you have we might be able to help you fabricate something.
Again, Welcome,
Herman
I was just hlock for responding to a reply and dont know why
-
2 hours ago, rossboyer said:Do you have the table top? If so, you might try Rockler, a woodworker supplier. They have stores all across the country. Don't think they would have the strip that mounts to wall. The top has a matching strip to hang the top on the wall. A folding or a leg that unscrews from top should be available at Rockler.
Thank you all.? Here is what it looks like. I have seen the hinge that mounts to wall and table that stays connected andnlowers down to the ledges by cushion but I havent seen one dor leg. You are probably right. I might just have to takenit off or replace it with a folding leg set up.
-
I have a 2005 alfa founder we just bought. It has dinette table that turns into a bed. Past owners never used it for that and does not have all the folding hinges needed for table to wall or folding up leg. Does anyone know if there is a kit for table and leg?
2005 Alfa See Ya generator starter
in Electrical
Posted · Report reply
I wish it was on a slide. Thats on my bucket list for our next rv. As far as starter removal. I found on an alfa forum that it can be replaced without removing generator from rv. Jack it up slightly after removing bolts to slide generator forward enough to open trap door. Access to starter. Thanks for the link on manual.