davebeach

Rich Thanks for the information. Dave

'mI asking about information when I go into the Diagnostic mode, Screens 5 and 6 contain past errors, like low ac or Dc voltage. My system shows all errors that have happen sometime in the past. I would like to reset them to 0, in the manual for units of serial # 832170 and higher it explains how. For unit # lower the manual gives no information on this subject. dave

Canyon Lake is a nice area, but it will get cool in the winter. We go all the south to the RioGrand Valley, another 250miles south. McAllen, Mission, Brownville area. Its tropical there with Palm trees and all. Lots of RV parks. If your are all set for this year something to trty for next year. Dave

Thanks Rich I cleaned contacts and unplug the ribben cable on the front control panel. All works great. Another question, How do you reset the error codes ( screens 6& 7) in diagnostic mode? I have the unit with S/N below 832170. Dave

I posted on Sept 1 asking questions about my Nocold 1200 Rifg, I got no responses. I must be in the wrong blog, I am new at this, where should I ask for help about the Nocold 1200. Dave

I have a Norcold 1200 LRIM in my 2000 MotorCoach. In the last year or so I been having problems, getting the Refig started after storage. I have all new batteries and completed the safety recalls. It turns on/ lights up gas or ac mode. My latest-- one day I got it to finally stay on in gas mode, had to restart it many times. Once it stay on every thing got cold. I put it on a low temp setting and it got cold. When I tried to a less cold, by holding the temp push button. the refig turned off. I cold start it up again but not change the temp setting. That was a couple of weeks ago, now I tried to start it again. I getting the same response. It will come on and run for about 1 hr on gas than turn off, the freezer started to get cool. I can't get to stay on in ac. It give me no error notes, just turns off. If I try to get to diagnostic mode, it turns off. There are two fans on the coils but they do not turn on. I reset the unit by removing DC power for a couple of min. When I turn it on the temperature setting where to max, five lits. I can not adjust this temp setting, when I try the control panel turns off. It will run on LP for 5-10 min. and than the control panel shus down, no error codes. Any ideas? Dave