Jump to content

coutch

Members
 View Profile  See their activity

  • Content Count

    8

  • Joined

  • Last visited

Posts posted by coutch

  1. Posted · Report reply

    I have had many of these burn out ... they have all had either a small bulb or neon bulb. I replace them with 12 volt LED, that are available at Radio Shack for a couple of dollar. The front red cover will pop off and the leads can be soldered in.

    An LED will last a lot longer than a bulb, draws less power, and is cooler.

    Thanks for the info. Radio Shack did the job and should be good to go for a long time with your comments. Thanks, Coutch

  2. Posted · Report reply

    Coutch,

    As you indicated, these small lights are wired to illuminate when the switch is "on". While I haven't seen your light, most of them can be easily removed from the back of the switch panel. If you unscrew the panel to which the switch and light are mounted, you'll likely find small fingers on two sides of the light unit. Press them in and the light unit can be pushed out through the front of the panel. Once you have the light unit removed and disconnected, you'll likely find a manufacturer's number on it. From that point you can either replace the whole unit or just the bulb by contacting your local RV shop, Camping World or Marvac Electronics.

    I hope this helps.

    Thanks for the information. I now have it fixed with the knowledge you gave. Thanks, Coutch

  3. Posted · Report reply

    After talking to dealers and repair shops as to the location for the OBD 2 Auto Scanner I've looked where they say it should be, but I still haven't located it. My ABS light comes on and off. If you turn the engine off and back on the light most of the time will go out. If I could locate the plug in I have the scanner to maybe tell me the problem. Thanks for any help you direct my way. Coutch

  4. Posted · Report reply

    I own a 1999 National Sea view 8330.

    When you turn on the 12 volt power switch a red light on the panel comes on and when turned off it goes out. It is the same size as the switch, like a rocker switch. This red light is burned out and I'm looking for a replacement or change the system.

    Thanks for any help you can give.

    Coutch

  5. Posted · Report reply

    I have a 1999 National Seaview on a F550 Ford chassis. The blower motor works on low, medium but not on high. The owners guide shows there is a fuse 15A for blower relay coil and in the power fuse box 40A Blower notor relay contacts. Before I take things apart I would like some direction or is there a relay or module on the blower? Thanks for any help, Coutch

  7. Posted · Report reply

    I own a 1999 Seaview class motorhome mfg. by National on a Ford chassis. I've tried RV dealers and camping world to see if I could obtain some type of an electrical and plumbing layout on this coach. I have been told the mfg. has so many models that they don't have any detail layouts available. Knowing the knowledge of the members of FMCA in this formum I'm looking for some help. If anyone can direct me where I might find or obtain these plans it would be very helpful. Thanks, Coutch

  8. Posted · Report reply

    I have a Generac generator in my motorhome. It would stop after 10 minutes but would start right back up and run for about 10 minutes, then stop again. I pulled the ground wire off the oil safety switch but still encountered the same problem.

    In checking the wiring, I discovered that both the oil and temp switchs were on the same hot wire. I disconnected the hot wire, and the generator ran for an hour with and without a load until I shut it down. Is there a way to check either switch to find the bad one? Or should I replace both and hope this was the real problem.

    Any comments are welcomed. I don't want to use the generator without the proper equipment. Thanks, Coutch.

×
×
  • Create New...