Jump to content
dhg2397

generator will not start, except with jumpers cables

Recommended Posts

I have a 2005 fleetwood southwind, generator will not start unless I hook jumper cables to it,  when I unhook it quits,  took generator out and had it checked runs perfect when not hooked to RV.  Just clicks when I try to start when it is hooked to RV, shows 13.4 volts coming to the generator, new batteries, any ideas will be geatly appreciated

Share this post


Link to post
Share on other sites

Gas genset, right? It requires constant voltage from some source to run. It's time to begin checking for voltage at the genset starter solenoid. BTW that 13,4V is not your batteries,, it is the battery charger voltage, good batteries at rest should read 12.8V when fully charged.

If you have voltage at that solenoid on one terminal, have someone try to start the genset while you check for voltage on both large posts. If there isn't voltage on both posts the solenoid/relay is defective.

With any 12V issue, begin at the power source and test the entire circuit until  you locate the fault, including the 2nd half of the circuit-the ground.

Share this post


Link to post
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now

×
×
  • Create New...