Sdmorton98@gmail.com Report post Posted December 15, 2023 I have an Atwood furnace that has quit working. I had traced it down to a bad control board. Checked the sail switch, high limit switch, reset switch and all checked out good. Discovered no power to blower motor from the board. Ordered a new board and installed. It worked once after I installed the board and nothing since. Anyone out there have any ideas? I just tested all three switches again and all checked out. Same as before, no power from boars to fan motor. What could be causing this? Thanks Sean Share this post Link to post Share on other sites
rls7201 Report post Posted December 18, 2023 I suspect the blower wire is not making contact in the end connector. Think about what you touched to make it work. Richard Share this post Link to post Share on other sites
