Jump to content
Sign in to follow this  
Cl7aude1

Marquis 7000 7NHMFA26106C Will Crank, But Not Start

Recommended Posts

My Marquis 7000 7NHMFA26106C will crank, but will not start. It was running fine about two weeks ago.

Parts that are Good:

Full Tank of New Fuel in Fuel Tank; New Spark Plugs; New Fuel Filter; New Air Filter; Oil

and Filter changed; New Spark Plugs; New Control Board.

Tests I have completed:

12V measured at P1-7;

10V measured at P1-6;

9.3V measured when connected Voltmeter directly to Fuel Pump and hit Start

Switch from Control Board. (I believe Fuel Pump should be able to run at 8Volt)

I disconnected Fuel Hose from Fuel Filter and put hose in Jar. When I hit

the Start Switch, NO Fuel came out of hose from Fuel Pump.

When I Connected a direct wire from a 12V Battery to the Pump, the Pump

pumped plenty of Fuel.

Anyone know what I might test next?

Share this post


Link to post
Share on other sites

WELCOME TO THE FORUM.

Check and see if you have a relay in the fuel electrical circuit. From what you have tested it has to be a relay or fuse for the fuel pump. :unsure:

Good, Luck

Share this post


Link to post
Share on other sites

As a final update. The Genset would run for about 3 or 4 minutes, then it would stop running. Genset started each time only after priming the Fuel Pump.

Solution: Replaced the Fuel Pump and it runs great. Thanks for your help.

Share this post


Link to post
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
Sign in to follow this  

×
×
  • Create New...