Jump to content
Sign in to follow this  
gregroelens

Alignment Specs for 1999 Allegro Bus

Recommended Posts

Does anyone have alignment specs for a 1999 Allegro bus on Freightliner chassis, caster and toe? Our Allegro is hard to drive in side winds, so we would appreciate any input. Thanks.

Greg and Theresa Roelens, FMCA#420496

Share this post


Link to post
Share on other sites

Greg, I do have the Freightliner Chassis Manual. I will need to go get it from its storage space tomorrow.

Will look up the information that it lists and pass it along.

Rich.

Share this post


Link to post
Share on other sites

Hi Greg,

Well, I found all the Shop Manuals.

They give the method of measuring the Camber angle,Caster Angle and Tow-in. and here are the settings listed.

[Axle Model ]

[Caster in Deg.(Bee] [Caster in Deg.(Bee] [Caster in Degrees ] [Toe in ( inches) ]

FC-941 [ (Degrees) ] [ (Degrees) ] [ Line Equip.Except ] [ Line Equip. LC ] [ (Hunter ]

FD-961 [ LC 4000 Model) ] [ 4000 Models) ] [ Equipment) ] [ -1/32 to +3/32" ]

FF-961 [ 0 +/- 7/16 ] [ 0 +/- 7/16 ] [ Power Steering: ] [ Power Steering: ] [ Power Steering: ]

FG-941 +2 to +5 [ +1-1/2 to +3-1/2 ] [ +1/2 to +3-!/2 ]

FL-941

If adjustment is required,set Tow-in as close as possible to +1/32"

Torque for nuts and clamps available!

You can use your Vin # and call Freightliner if you need to get the proper Axel part numbers. They do very and it would be a good idea to check. If they are different,then ask for the proper settings for the axles used.

Hope this information is use full.

Rich.

Boy when I post the chart it scrambles things well

Front Axel information.pdf

Share this post


Link to post
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
Sign in to follow this  

×
×
  • Create New...