gregroelens Report post Posted April 14, 2012 Does anyone have alignment specs for a 1999 Allegro bus on Freightliner chassis, caster and toe? Our Allegro is hard to drive in side winds, so we would appreciate any input. Thanks. Greg and Theresa Roelens, FMCA#420496 Share this post Link to post Share on other sites
dickandlois Report post Posted April 18, 2012 Greg, I do have the Freightliner Chassis Manual. I will need to go get it from its storage space tomorrow. Will look up the information that it lists and pass it along. Rich. Share this post Link to post Share on other sites
dickandlois Report post Posted April 18, 2012 Hi Greg, Well, I found all the Shop Manuals. They give the method of measuring the Camber angle,Caster Angle and Tow-in. and here are the settings listed. [Axle Model ] [Caster in Deg.(Bee] [Caster in Deg.(Bee] [Caster in Degrees ] [Toe in ( inches) ] FC-941 [ (Degrees) ] [ (Degrees) ] [ Line Equip.Except ] [ Line Equip. LC ] [ (Hunter ] FD-961 [ LC 4000 Model) ] [ 4000 Models) ] [ Equipment) ] [ -1/32 to +3/32" ] FF-961 [ 0 +/- 7/16 ] [ 0 +/- 7/16 ] [ Power Steering: ] [ Power Steering: ] [ Power Steering: ] FG-941 +2 to +5 [ +1-1/2 to +3-1/2 ] [ +1/2 to +3-!/2 ] FL-941 If adjustment is required,set Tow-in as close as possible to +1/32" Torque for nuts and clamps available! You can use your Vin # and call Freightliner if you need to get the proper Axel part numbers. They do very and it would be a good idea to check. If they are different,then ask for the proper settings for the axles used. Hope this information is use full. Rich. Boy when I post the chart it scrambles things well Front Axel information.pdf Share this post Link to post Share on other sites
