haljudi Report post Posted May 6, 2012 I'm attempting to install a TV in the exterior compartment of my 2011 Bounder. The antenna terminal is there along with 3 jack points labeled audio left, audio right and video. I hooked the 75 ohm connector between the outlet and the TV, then I ran a cable from video output to the input side of the TV. The satellite input worked but only gave me a black and white picture with no sound and I couldn't get the DVD player to show up on the TV. The unit is supposed to be pre-wired for this set up. What am I doing wrong? Share this post Link to post Share on other sites
Guest BillAdams Report post Posted May 6, 2012 Are you using a HD satellite receiver? If so, you may have connected the cables to the incorrect outputs on the satellite receiver. I would suggest that you have someone inside try each of the inputs to each of the available connections as they may also be mislabeled. The yellow connection is what will send your video to the TV and red and white are left and right audio. It will not be HD at that TV but you should be able to get a very good picture. Share this post Link to post Share on other sites
