LloydW Report post Posted October 12, 2013 The last two days of travel the engine will not shut off after approx. four hours of travel, this is with the the ignition switch off and the key removed. The solution has been to shut off the battery isolator switch. The system seems to work fine after that until the next few hours of operation.This is in a 2005 beaver. Suggestions please. Lloyd Share this post Link to post Share on other sites
huffypuff Report post Posted October 12, 2013 Good news is it's electrical not mechanical. Somehow the shutoff solenoid is being fed electrical power when you shut off the ignition. You can verified this with a test light and unplugging the solenoid when engine is running. If engine shuts off at that point then try unplugging the ignition switch while engine is running. If engine shuts off when you disconnect the ignition switch, you found the problem. if not you need to take it to a chassis shop. Share this post Link to post Share on other sites
LloydW Report post Posted October 12, 2013 Thanks Ray, I have just talked with my dealership and was advised that it was a backfeed from the daylite running lites [a Canadian requirement]. The solution is to have the headlite switch on and on low beam when you shut down. Seems to work. lloyd Share this post Link to post Share on other sites
