wildebill308 Report post Posted November 18, 2013 I had a good project this weekend. I changed the kitchen faucet in my Bounder. Every thing was pretty straight forward. I only had a couple of stumbling blocks. I needed to get a couple of adapters to hook up the water lines and the center hole in the sink needed to be ground out a little. The problem is the base of the faucet was a little wider than the lip/flange on the back of the sink. I could have sanded down the flange, it would have been easy with a belt sander. I decided to grind a notch in the center hole of the sink that the water hoses come through to allow the faucet to set flat. I am really happy with the new faucet it is higher and has a pull out head with a spray feature. I think this is a great upgrade and wish I had done it sooner. Bill Share this post Link to post Share on other sites
