rogerbet Report post Posted March 6, 2009 My A/C and furnace cycle on and off too frequently on zone 2. I've been told there is a setpoint adjustment under the cover, but I don't know how to remove the cover. Any help would be appreciated. Share this post Link to post Share on other sites
dr4film Report post Posted May 8, 2009 Carefully remove the base plate from the Comfort Control Center . This may be accomplished by inserting a small screwdriver under the tab on the bottom edge of the front cover and gently prying. See FIG. 9 of the attachment. CCC_Photo.doc Share this post Link to post Share on other sites
diamond1041 Report post Posted October 17, 2011 Did you find the set point this is what mine is doing I have a Coleman 5 button due them thermostat now that I need the furnace put it on zone 1 and furnace it lights and the fan comes on set the temp to 75 then in about 15 min. everything shuts off I know the temp never got to 75 it will not restart on its own turn the switch to off and back on everything starts up the shuts down again in about 15 min anyone now what is going on with the thermostat if you got yours working what was it Share this post Link to post Share on other sites
Goldwing2 Report post Posted February 4, 2015 see RV Comfort Control.ZC Share this post Link to post Share on other sites