gbellar Report post Posted September 3, 2016 When changing channels on the dish receiver I have to have the cabinet door and the remote about 6 - 8 inches from the receiver box this is in a Tiffin Bus. There is a blue flashing light mounted next to the TV which used to relay the signal to the box. What do I need to do to change channels without going next to the box. Share this post Link to post Share on other sites
wayne77590 Report post Posted September 4, 2016 Are you using an IR sender or RF? RF is much better than the IR and to my knowledge Dish receivers are capable of either one. IR needs direct line of site. RF, well I just point mine at the ceiling and the channel changes. Or point it anywhere. Share this post Link to post Share on other sites
