tarheels293

Has anyone one out there had luck finding calipers, rotors, pads for the 2001 HR Ambassador. If I'm understanding right, I've got the phenolic piston in my calipers. If the RV sits for 3 to 4 weeks the calipers sticks. I can drive it down the road 4 or 5 miles and put heat in the brakes, let it sit over night and it does fine on the trip. I've changed the brake fluid and that really helped. It's on a Roadmaster chassis model 26000. I'm really hoping to find someone who has changed there's and has parts numbers....thanks again guys.. 2001 H/R Ambassador Monaco coach #120383 36pbd ISB 300 eng. VIN # 1RF12041912012180 (8/2000)

Fjleamont, I wish I could pled the fifth on this one. But since you asked I will tell my ignorance. After tearing out all the fuse boxes and tracking down all those wires. The power shutoff switch at the door was CUTOFF!!! I was reading daniel92870 post when wolfe10 said did you check the salesman switch by the door.........omg......no dog and grandchildren weren't out there, so this was on ME. Thanks

Thank you guys this has been a big help. Hope in the future I can repay the favor.

I am looking for a wiring diagram for an 01 HR Ambassador 36 PBD. I have lost the 12 volt feed to the rear fuse box. The Intellitec 50 amp EMS Distribution panel (760) doesn't have the 12V at J2 3 PIN connector. I can run 12V jumper from batteries to fuse box and everything works perfect. I just don't know where it gets its 12V feed. I have checked all the fuses that I can find. I would appreciate any help is can get. Thanks.

I currently have a 2001 H/R Ambassador 36' class A 5.9 L Cummins diesel w/ISB 300. 7500 watt quiet gen on a Roadmaster chassis w/Allison 3000 trans. I'm looking for a website where I can get an electrical diagram. I'm having a problem w/A/C units. Front A/C not working back one does. Also problems with coach electrical terminals. I tried to find info on this RV and its virtually impossible. I am looking for a wiring diagram for an 01 HR Ambassador 36 PBD. I have lost the 12 volt feed to the rear fuse box. The Intellitec 50 amp EMS Distribution panel (760) doesn't have the 12V at J2 3 PIN connector. I can run 12V jumper from batteries to fuse box and everything works perfect. I just don't know where it gets its 12V feed. I have checked all the fuses that I can find. I would appreciate any help is can get. Please help!!! Thanks!!