Jump to content

RaymondBirt

Members
  • Content Count

    2
  • Joined

  • Last visited

About RaymondBirt

  • Birthday 02/04/1950

Profile Information

  • Gender
    Male
  • Location
    Eatonton GA 31024
  • Interests
    Woodworking, Boating, Old Cars, Gardening & Nascar Races
  1. I have a 2006, 34ft Itasca Gas MH. The water pump will not stay running when the water is on. If I wiggle the wires that plug into the pump it will come on when its calling for water. Once I think I have it fixed or try it later, the same thing happens. My question is do you think I have a bad connection or the pump is bad, or is there some kind of relay I need to check? The Water pump is a Shurflo 2088-403-144 Also, I turned on the water pump switch and removed both leads from the water pump and I was getting 13.75 volts, that tells me the switch is fine and power is getting to the pump. I also took some WD -40 and sprayed on the terminals to clean them and cleaned the pieces on the end of the wires. If I wiggle one of the wires and pulled up on it just a little, it goes to working, but soon as I go in the coach and cut the water off, then turn it back on it quits. Is the end of the pump where the wires connect removable or replaceable? Any help will be appreciated, RB
  2. I am looking at buying a 5 Speed manual tranny 07 VW GTI which I think has the same transmisson as a Jetta, I read the manual. It didn't really say, but it did say you could not tow an automatic. Do you know if I can Flat Tow this Vehicle, it is not listed under 2007 Towable in FCMA. RBirt
×
×
  • Create New...