Jump to content
Sign in to follow this  
bobschultz

Bath vent fan cover not working

Recommended Posts

Our bath vent fan cover will not go up. The two gears off the cover motor are working fine. It appears that the cover arm is not engaging properly with the motor gears. The fan motor is a Jenson by Elixir, Model # V971232E-C; but I see no name or model number on the actual cover motor. Is there a way to repair the cover arm or will I just have to buy a new cover assembly (arm, motor, etc.)? Thanks for any advise. 2009 Winnebago Journey

Share this post


Link to post
Share on other sites

Bob.

Have you been on the roof and looked at your amenture?  Probably sliped out of it's grove.  You should be able to open the cover from inside, manually!

Share this post


Link to post
Share on other sites

The drive motor with knob is about $45.00 and the lift arm is $11.00.

Just replace both on my bath exhaust fan. Two screws hold the drive motor onto the case. Four screws hold the case cover on. When you drop down the arm is held up with would screws. 

Remove motor then case cover. Replace lift arm and reverse operation. 

Motor is splined as is the lift arm. 

Hope this helps.

Herman 

Share this post


Link to post
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
Sign in to follow this  

×
×
  • Create New...