MONTIE Report post Posted May 6, 2010 I have looked at all the posts concerning slideouts and have read the same question I am going to ask. Where can I find simple directions concerning the adjustment of a slideout? I have a full-wall slideout on a 40-foot Monaco Knight DFT. The thing operates good and I have adjusted but I cannot get the bottom and the top to close at the same time. it either leaves a crack at the top or bottom or it closes right on one end and not the other. I can't seem to find that middle ground that makes it tight all the way around the slides. When I first started there was an 1-inch crack at the bottom. I have that closing tight now and the top has a small gap; maybe it is supposed to be that way. If I could read the directions I believe I could make it work, but I cannot find any help. HELP. PLEASE. Share this post Link to post Share on other sites
boatbearme@gmail.com Report post Posted May 9, 2010 Unfortunately, the full-wall-slide was another nail in the previous Monaco's coffin. Dealers all over were left with these models in inventory when the company folded - most seem to have been sold due to the scarcity of DP models to buy over the last year. They had a bad reputation. The two I looked at didn't seem to have enough rigidity to keep the entire slide "square". Your best bet is to contact the "new" Monaco to see if you can get support Share this post Link to post Share on other sites
doublechevy Report post Posted May 12, 2010 I also have a 2008 Monaco Knight DFT There is no problem with the full wall slide on my coach it closes perfectly every time with no gaps anywhere I am sure that it can be adjusted to close correctly. as it should have been when it left the dealership and the factory. I am sure that tech support can assist you as they have been very helpful when I contact them about any issues except for warranty. Share this post Link to post Share on other sites
