KarenLangston Report post Posted November 18, 2021 Hi, we have have a 2002 Monaco Holiday Rambler Navigator. We are currently at Rev. not sure if it is the gauge or the wiring. Does any one know of where we can get ahold of water temperature gaugue? Or Is there a fuse that could go with this? Thank you, Share this post Link to post Share on other sites
kaypsmith Report post Posted November 18, 2021 Probably not the gauge that is bad. https://www.google.com/search?q=whow+does+a+water+temp+guage+work+in+a+mh&oq=whow+does+a+water+temp+guage+work+in+a+mh&aqs=chrome..69i57j33i10i160l3.45749j1j15&sourceid=chrome&ie=UTF-8 The temp sending in the block could be bad, or a wire has been cut or broken, or has a lot of crud on it inside the block. With the illustration in the above link, it is easy to test. To test the gauge, the positive and negative wires must be put in place, then short across the two wires to the sending unit, if the gauge pegs out then the gauge is probably ok. Welcome to the forum, hope this helps. Share this post Link to post Share on other sites
jleamont Report post Posted November 19, 2021 https://www.autometer.com/gauge-types/?gclid=Cj0KCQiAkNiMBhCxARIsAIDDKNWMyOvOUVXZ0GxR17buj9uUTrjr_F7akygiIKlXkxSiPU7oLXghwHwaAs20EALw_wcB&gclsrc=aw.ds the factory gauges were made by VDO. That link is below. You can purchase one from Autometer. The link above, scroll down and contact them. I know they make custom gauges to fit your needs. https://www.vdo-gauges.com Share this post Link to post Share on other sites
