luvmemonaco Report post Posted June 2, 2024 Hello, all, and profuse thanks in advance for your help. Here's my question... I have a 2018 Chevy Malibu, that I tow behind my RV, 4 down. The only requirement is that I remove 2 fuses from the fuse box, under the driver dash. The fuse box access is incredibly tight, and i sometimes end up dropping the fuses down into the no mans land between the fuse box, and being lucky and it landing on the floor. Prior to this vehicle, I had a Honda CR-V, which i was able to install a toggle switch setup to not have to remove the fuses, just flick the switch and you're done. Is there a similar setup to put in my malibu, so i dont have to take off and put back on, just flick a switch.... Kevin Ross Share this post Link to post Share on other sites
moonwink Report post Posted June 3, 2024 https://www.etrailer.com/s.aspx?qry=Fuse+Bypass+Switch Take a look at the link above. You should be able to find something that will work. Share this post Link to post Share on other sites
wildebill308 Report post Posted June 3, 2024 What were you turning off on the CR-V? Bill Share this post Link to post Share on other sites
luvmemonaco Report post Posted June 4, 2024 thank you, moonwink- thats exactly what i was looking for....and wild bill, i was pulling fuses on the cr-v Thank you both! Share this post Link to post Share on other sites
wildebill308 Report post Posted June 5, 2024 7 hours ago, luvmemonaco said: .and wild bill, i was pulling fuses on the cr-v Yes I know but what fuses and why? I have a CR-V and don't pull any fuses. Bill Share this post Link to post Share on other sites