Whoachubby Report post Posted February 19, 2012 Not sure why I took on this project. Ordered a new seal for aqua magic toilet. Took everything apart replaced seal and the plastic housing that holds the blade has 18 screws holding 2 pieces together. When I tighten the screws down the blade is very hard to open and close. I put everything back in same order. So can't understand why the blade gets jammed up on the reinstall. Anyone have any experience with this type of issue. It is an aqua magic aura model. Share this post Link to post Share on other sites
desertdeals69 Report post Posted February 19, 2012 You maybe over torqueing the screws. I presume you have lubed it. Share this post Link to post Share on other sites
Whoachubby Report post Posted February 19, 2012 I loosened the screws a little. There is another gasket that goes around the outside. It is probably worn also. Will call tech support tomorrow. Would have been much better to replace toilet. Share this post Link to post Share on other sites
