DCraig Report post Posted August 4, 2012 What can be done about this error message? Is it possible to reset? If so what is the procedure? Share this post Link to post Share on other sites
tbutler Report post Posted August 5, 2012 Call Monaco RV LLC at 877-466-6226, ask for technical service. Be prepared to give your coach number. They should be able to help you. Share this post Link to post Share on other sites
dickandlois Report post Posted August 5, 2012 Do not know if you have a M-line instrument panel,but this might help. Page 7 TROUBLESHOOTING In-depth troubleshooting of an instrument panel is best done at the Actia factory/Authorized Service Center. Simple electrical troubleshooting can be done in the field by using test probes, multimeters and clip leads. +12 VDC can be supplied from a bench top supply or a storage battery. Careful checking of wire continuity, wire connections and terminations, sender function and gauge operation should be done to determine which component has failed. Symptom Possible Cause ___________________________________________________________________________ Gauges do not respond when ignition - Missing or broken ignition or ground wires is turned on. ___________________________________________________________________________ Gauge(s) read erratically - Loose connections at sender, gauge and/or connectors ___________________________________________________________________________ Speedometer reads too fast or too slow - Speedometer not properly calibrated to the correct pulse/mile or pulse/kilometer count. ___________________________________________________________________________ Speedometer does not indicate speed - Missing or broken sender wire(s) - Sender has failed internally ____________________________________________________________________________ Speedometer indicates speed, but is - Electrical noise from alternator, power and/or Erratic ground distribution panel studs, transmission ___________________________________________________________________________ External Odometer accumulates - Odometer is not programmed for the correct mileage too fast or too slow pulse/mile or pulse/kilometer count ___________________________________________________________________________ External Odometer display says - Odometer detected an internal failure during “ERR 1” power-up. (Odo will need to be replaced) ___________________________________________________________________________ Tachometer does not indicate engine - Missing or broken sender wire(s) Speed ___________________________________________________________________________ Fuel Gauge reads Empty all the time - Fuel tank empty - Sender wire missing, cut or broken - Sender broken, missing float, etc. - Internal failure of gauge Circuit board Assembly (No field serviceability) ____________________________________________________________________________ Rich. Share this post Link to post Share on other sites
