WorkHorse W-22 Chassis - Sway Bar

[djordan1677]

Can anyone help with finding sway bars for front and rear of a workhorse w22 chassis. 2003 Monaco Monarch se36. Possibly looking for used. I've looked on line for salvage yards but which one can I trust. Thanks Dennis

[ClayL]

What is wrong with the ones you have?

By the way if your chassis is older than 9/2/2003 you have a 2 inch bar in the front. After that date Workhorse changed to a 2.5 inch bar which was a huge improvement.

My 2004 motor home was built on a 2003 chassis made before that date so I installed the 2.5 inch one.

Made a big improverment in:

1. Reduced Body Roll when cornering.
2. Reduced "rocking" when passed by or passing large vehicles.
3. Reduced "rocking" when traversing bumps on an angle.

[djordan1677]

Thanks Clay for info. I do have a question then. I have square tube bars in the front and rear that are attached to the leaf springs. But the bars that i'm use to are the round tubes. There made by Roadmaster and Helwig. Have you ever looked into this type for better handling. What have you done for the stabilizer bar.

[desertdeals69]

Check with Roadmaster for upgrades