wilkiesr Report post Posted January 19, 2014 Need a place to buy a new dash panel for my 2000 Windsor. Any help would be appreciated. Thanks Wilkie Share this post Link to post Share on other sites
F355197 Report post Posted January 19, 2014 You might try Northwest RV Supply (http://www.nwrvsupply.com/). They had a lot of dash panels at one time but the last time I was in there, their supply had diminished. Give them a call because the website does not reflect their entire inventory. Jack Share this post Link to post Share on other sites
wilkiesr Report post Posted January 20, 2014 I'll call them tomorrow. Thanks Share this post Link to post Share on other sites
F355197 Report post Posted January 22, 2014 Have you found a dash panel? If not, when we had our 98 Beaver Contessa, I didn't like the looks or layout its dash panel so I fabricated one from 1/8" aluminum laminated with Wilsonart laminate and was pleased with the result. Share this post Link to post Share on other sites
Walt2137 Report post Posted February 8, 2014 I'm with Jack on the replacement for the dash on a Monaco, I replaced the shift panel to the left of the driver on our 2000 Dyn with 1/8 aluminum no more worries about it cracking, I have seen the dash replacements in Elkhart salvage also. The dash replacement is going to be a bear to change, I gave a dash and shift panel I had for a Diplomat to a friend that had a 01 Dip, to start with the replacement was only the thin skin outer piece you see the thick plastic that is on the inside had to be removed from the old dash and reattached to the new dash he also used a different type screw to keep it from cracking the plastic around the screw (the screw type Monaco used is the problem besides the flimsy material) I will paste below. The box says Au-Ve-Co Products, or Auto-Vehicle Products. The screws are #0162744, or #12215, Phillips flat top washer hd. tapping screws. They measure #8 x 3/4 inch and are black screws. # 8x 1” 0162745 ( I went with the 1 inch) Share this post Link to post Share on other sites
GDPirie Report post Posted May 15, 2014 I have a new 2000 Windsor Dash panel, still in the Actia box. It is in Federal Way, WA if anyone is still interested. Regards; George Share this post Link to post Share on other sites
Derbyfever Report post Posted February 24, 2015 Do you still have the dash available? I have a 1999 Monaco Windsor and curious if it would fit. Share this post Link to post Share on other sites
jleamont Report post Posted April 2, 2015 I removed mine and had a local plastics shop duplicate them in wood grained plastic. The Monaco plastic was cheap garbage. Out the door it cost me $400.00 for all trim panels in the front of the coach plus no more dull dingy gray plastic, looks classy now. Before and after photos below Share this post Link to post Share on other sites
dickandlois Report post Posted April 3, 2015 Did you have a switch replaced or repaired also? Rich. Share this post Link to post Share on other sites
jleamont Report post Posted April 5, 2015 Rich, if you are asking me, no I took the picture after I started to disassemble it, I thougt if I took a photo with my cell phone I could see how they were layed out when the new one arrived rather than trying to reassemble from memory.....but what a difference huh? Joe Share this post Link to post Share on other sites
dickandlois Report post Posted April 6, 2015 Joe, Turned out real nice. The new one dresses up the area !! Rich. Share this post Link to post Share on other sites
