bigkelly

Gentlemen, Can anyone give me some pointers on installing a led light strip on my curb side slide out. I want to install the strip at the top. My question is where to run the power supply into the coach at. I have an ac to dc convertor located in the compartment with the TV connections on the overhead R/S above the passenger seat. My concern is the power supply cord must move with the slide out. Have any of you with this make and model performed this task? The upper vent for the Frig is the closest point that I see to access with drilling. However I don't see any place to access that area from the inside. I hope I'm not over thinks this. ( I tend to do that at times). Any advise will be greatly appreciated. Thanks.

I will have to get those weights. My wife is using it for the next couple weeks working out of town. Thanks for the reply I will post that information when she returns.

Can anyone give me a good starting point for tire pressures? The tires are 275/80R 22.5. I can only weigh the axles individually, Gross weight including my trailer is 51,600. I have 105 psi in my steering tires. I'm unsure as to how much pressure to inflate the dual drives and tag axle tires to. Thanks. Kelly

Nylon fishing line works great to cut through the tape. will not scratch or damage paint. long piece work back and forth between body & emblem

I have followed the 4 pin back to where it ends as a 6 pin flat connector. There is an additional single wire outside that connector that is running inside the flexible split shield cover. I am assuming all 6 wires are still inside the cover possibly taped back. As for the trailer. Its a 20 ft. utility Sure Trac, we haul 2 Polaris razor 1000 xp side by sides. total weight around 4200#. The towing capacity is rated for 10000#. Vehicle weight is 43,000 # Combined gross is 53,000 # Thank you for the reply.Kelly

Hello, I'm new to site. Recently purchased used 2010 HR Endeavor 42skq. Was this model wired for trailer brakes thru the OEM 7 pin receptacle? Previous owner remover 7 pin and install 4 pin for tow bar set up. I do not see a controller mounted externally. I'm not sure if I need to install a controller and wiring to give trailer braking thru the 7 pin. Any help or suggestions would be greatly appreciated. Thanks, KELLY