Jump to content
slider_48167

Front Window Shades 2003 Signature

Recommended Posts

We have a 2003 Signature Supreme. To have the driver's window repaired they had to remove the blind. It worked when it went up-after the window work it will not activate.

1) Does anyone know who would have made the blinds? There was no marking at all on it.

2) I can see that the assembly is held by two clips. I have tried using a screwdriver blade to 'unclip' but can't seem to move the clip fingers. Any suggestions?

 

Herman, thanks for your response. 

Share this post


Link to post
Share on other sites

slider,

Your front power awning is held up with 2 screws. One at each end and they are in slots on each plastic end. The longer of the two plastic ends contains the drive motor.  Loosen the screw on that end and remove the screw on the other end. You should be sure and support that end as you remove that screw. You may then slide the awning off. Sounds to me as if you have a wire come loose.

Herman 

Share this post


Link to post
Share on other sites

If you don't have a helper, use a long shoelace (tennis shoe) and tie onto end off where you will remove screw, tie the other end to a knob or handle, off a cabinet above!  Been there, last September!

Carl

Share this post


Link to post
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now

×
×
  • Create New...