eric@babin.com Report post Posted November 7, 2019 Most should know if you have problems with your stairs not going in, or not going out, it's frequently the fact the contacts are dirty. A little sandpaper on them and you are good to go. or.... a wire came loose.... take the contact assembly out a little and connect wire. Our stairs began going in and out while we were driving..... contacts were clean..... I took a close look from the side of the contacts and noticed one was shorter than the others..... I pulled the assembly out and upon close inspection, I noticed they are adjustable by pulling the wire off, and using the plastic nut to adjust the length / how far they stick out. See pictures. One note, be sure to remember which side is up (in my case the yellow wire) and not take off more than 1 wire at a time unless you mark them for proper location. Share this post Link to post Share on other sites
manholt Report post Posted November 9, 2019 Eric, that's excellent information on all three problems! Great photos. Carl Share this post Link to post Share on other sites