donaldrfiske Report post Posted March 23, 2020 AC and heater run but don’t cycle off at set temperature Share this post Link to post Share on other sites
huffypuff Report post Posted March 23, 2020 34 minutes ago, donaldrfiske said: AC and heater run but don’t cycle off at set temperature Whats the year make and model of your coach? What A/C, heater system are you talking about. Share this post Link to post Share on other sites
donaldrfiske Report post Posted March 23, 2020 06 holiday rambler ambassador and Atwood heater Share this post Link to post Share on other sites
donaldrfiske Report post Posted March 23, 2020 There’s a sensor in living area that operates under zone 1 and this heater cycles properly the zone 2 heater for bath and bedroom runs constantly not cycling off at set temperature Share this post Link to post Share on other sites
manholt Report post Posted March 23, 2020 Is there a separate sensor for bath/bedroom? Where are the registers located in relationship to sensor/sensors? Share this post Link to post Share on other sites
donaldrfiske Report post Posted March 23, 2020 Zone 1 sensor is located in living area and cycles properly with that furnace zone 2 sensor is located in bedroom and zone 2 heats bed and bathroom with 1 register in bedroom 1 in bath area and one under refrigerator Hope I explained it properly Share this post Link to post Share on other sites
huffypuff Report post Posted March 23, 2020 22 minutes ago, donaldrfiske said: Zone 1 sensor is located in living area and cycles properly with that furnace zone 2 sensor is located in bedroom and zone 2 heats bed and bathroom with 1 register in bedroom 1 in bath area and one under refrigerator Hope I explained it properly I have a 06 and know the system. I have to look it up but I would try a thermostat reset. Owners manual attached. https://www.holidayrambler.com/resources/media/manuals/2005_Ambassador.pdf Share this post Link to post Share on other sites
donaldrfiske Report post Posted March 23, 2020 Well lol hope your ready for this .... took wall sensor cover off in bed room and the thermostat wire was back behind the wall I was able to fish it out. Turned furnace on and **** if it didn’t cycle on and off to the temperature set at. Guess it wasn’t getting a true reading behind the wall !!! Anyway I secured the wire so it can’t fall back into the wall again replaced the cover and we’re good to go want to thank you for your help and time on this problem !! Share this post Link to post Share on other sites
huffypuff Report post Posted March 23, 2020 18 minutes ago, donaldrfiske said: Well lol hope your ready for this .... took wall sensor cover off in bed room and the thermostat wire was back behind the wall I was able to fish it out. Turned furnace on and **** if it didn’t cycle on and off to the temperature set at. Guess it wasn’t getting a true reading behind the wall !!! Anyway I secured the wire so it can’t fall back into the wall again replaced the cover and we’re good to go want to thank you for your help and time on this problem !! I would think it would have at least one cable staple on it to hold it. Share this post Link to post Share on other sites
