chuckconnie Report post Posted July 31, 2022 Other than wood, any suggestions for blocks under hydraulic leveling jacks ? Have not heard many good remarks about Camco plastic pads most seem to break with first usage. Share this post Link to post Share on other sites
five Report post Posted July 31, 2022 I've got four heavy wood jack pads with about 70k on them riding in the MH....never used them. Share this post Link to post Share on other sites
chindog Report post Posted July 31, 2022 I've got a couple of bags of Valterra Stackers, otherwise known as the Lego pads. They have held up well under my jacks, with up to 11,000# on each stack on the back jacks. They do need a solid surface under them, though. On gravel, the bottoms can get chewed up, so I put them on a section of 2x12 board. Share this post Link to post Share on other sites
mypopslou Report post Posted August 2, 2022 I just added snap pads, easy to install and so far I am very pleased with them. Prior to purchasing theses I used 4 inch thick wood blocks which were extremely heavy to carry around. Share this post Link to post Share on other sites
lmacleod Report post Posted May 23, 2023 Which brand of pads did u buy. I bought SnapPad EXTA. Have lost one already in transit on first trip. It was correctly installed. Share this post Link to post Share on other sites
rayin Report post Posted May 28, 2023 If your brand leveling system is HWH, they say to never use more than one wool leveling block under each jack for safety reasons. The plastic pads click together so they cannot slide sideways. chindog is right about crushed stone or gravel destroying the bottom one. Nearly everyone knows this, but JIC, never raise the rear axle of a MH off the ground! Share this post Link to post Share on other sites
