MichaelC Report post Posted October 14, 2013 I have a 1998 Winnebago Adventurer - the slideout is stuck half in and half out - any suggestions? I heard a loud popping sound and it quit working. Share this post Link to post Share on other sites
dickandlois Report post Posted October 14, 2013 A sharp popping or snapping sound could be the coupling or shear pin breaking. Was the sound from a dual drive rail slide system? or a single drive rail system? Do you still have power to the drive motor ? Could you post the manufacture of you slide out system for the group. Rich. Share this post Link to post Share on other sites
huffypuff Report post Posted October 14, 2013 I had the shaft break in half on bearing coupler and made the same noise. In my case was replace the bearing assembly with it's two brackets about $90 part. I was abled to push the slide in with a couple of people. Lucky that slide wasn't too big to handle. Share this post Link to post Share on other sites
Howde Report post Posted October 14, 2013 We had this happen a week ago. My husband was putting down the leveling jacks and we heard a pop. I noticed that the one slide had slightly popped out. It was the pin in the motor that broke. We had a repair service come out. He pulled the slide out manually because it was our bedroom slide and the only way to access it was under the bed. Anyway, 3 hours later he replaced the pin and so far it's working good. Hope you are able to get yours fixed soon. Share this post Link to post Share on other sites
