tom73

That's what I was thinking. We'll see what the insurance company (Humana/Medicare) says when the time comes.

Wife had a Dr. appt. today and the doctor would like her to get her A1C checked in about 6 months. What type of medical facility would be best for when the time comes? Clinic, hospital? worst part is, we don't even know where we're going to be then..............

I was thinking about one of these, but decided that for what I do I will use my phone as a hot spot. It's a TMobile phone and the unlimited data hot spot is a $15 add on. I don't know if that is still offered since wife and I got our phones a few years ago.

Here is another suggestion....... Fill the sink, keep the grey valve closed and use a plunger if it will seal in the sink. The key is to try to work the plunger fairly fast and then push down hard to get it compressed. Then pull it back up quickly. That may dislodge what ever is lodged. With the grey tank empty the sink should drain some until the tank gets some water in it. You can also try the same thing in the shower.

Over the last spring I noticed the pin box was going up into the body of my trailer by about an inch. I nursed the trailer to where we (wife and I) spend the summer (we full time) and tore into it. I found the corners had small cracks, but nothing that would allow the pin box to move like it was. After really looking at things the design of the frame was sorely lacking....... I discovered that there were bolts that ran through the body (from the inside) to the frame in the bedroom. I was able to access six of them but couldn't find others. Out of the six ONE was snug, and two of them were sticking out about 1/2"! Where the 2'X6" frame comes from the front and meets the frame where the drop is they didn't bother to weld the bottom! I bought 20' of 2"X2" angle iron and cut four pieces about 3 feet long. I bolted them to both frame members so that one side was horizontal and the other side was vertical. I took them out and welded them together. There are now 26-5/16X3/4" fine thread grade 8 bolts holding the two pieces so they can't move like they were. I wanted to weld the frame, but it was too tight and the proximity of the body was concerning. I did weld the cracks you see in the pictures. Now when I hook up the pin box only moves about 3/16"!! Woo Hoo!! I guess I will find out this fall if I did a good job or not........ We're heading to the west coast from Minnesota and going to work our was south this winter.

The problem with the EZ Lube is that a lot of people with them just grab a grease gun and pump the **** out of it then complain about the seals not stopping the grease. Personally, I pack them once a year if possible, but I have gone two years with no issues either. Every stop I walk around and put the back of my fingers on every tire and hub.

Got it, Thanks!

You mean to the FMCA site? That's the only place I can log into. The Tech Connect+ home page has no place to sign in. edit: I signed in to the FMCA site, went to my profile and then to the Tech Connect+ tab. Still nothing........

Tried that and got nowhere. Anybody have a way to sign up for this MIFI? Tom