wolfe10 Report post Posted October 27, 2018 May be as simple as reinserting the gang plug. May be the shift pad, wiring or ECU. Start with the easy/inexpensive stuff. Share this post Link to post Share on other sites
chollenback Report post Posted October 30, 2018 Just to close this out...I went ahead and removed entire electronic shifting mechanism and tore it apart. I separated keypad from ECU and then opened up ECU and cleaned all brass connections and keypad metal contacts. Put it back together and worked good. There is a 3 second delay for each gear when I press D, N or R. At least it works. Thanks to all. Share this post Link to post Share on other sites
dickandlois Report post Posted October 31, 2018 Thanks For the feedback and glad you got it working. Oxidation and bad grounds are troublemakers for all of us! Rich. Share this post Link to post Share on other sites
wildebill308 Report post Posted October 31, 2018 Glad you got it working and Thanks For the feedback. Bill Share this post Link to post Share on other sites
f433921 Report post Posted October 31, 2018 Thanks for the reply, it's sure rewarding when you can do you own repairs. Jim Share this post Link to post Share on other sites
actionjackson Report post Posted November 4, 2018 We had a 96 Vectra with the Allison MD3060, which, I assume you have. We had the same thing happen to us many years ago. The Allison is designed to be "Farmer Proof". In other words it will shut itself down for any reason. Our problem was "no throttle". The Allison computer lost contact with the throttle. If you can go under your coach and see if you can find the throttle cable that enters the transmission. It is held and secured by a "C" clamp. Our "C" clamp had broken off and the cable was allowed to wiggle around, causing the transmission to shut itself down. It was simply a matter of replacing the C clamp and re-educating the computer. Hope this helps. Share this post Link to post Share on other sites