keithl Report post Posted July 23, 2019 Last few weeks I was out I would start leveling only front would till I tried second time then all worked properly . Now this week second stop only rear go down and I have to manually set front any help I’m not real knowledgeable on these hoping I can learn some in minot but for I will appreciate any clues Keith Share this post Link to post Share on other sites
dickandlois Report post Posted July 24, 2019 On 7/22/2019 at 8:12 PM, Keithl said: Last few weeks I was out I would start leveling only front would till I tried second time then all worked properly . Now this week second stop only rear go down and I have to manually set front any help I’m not real knowledgeable on these hoping I can learn some in minot but for I will appreciate any clues Keith Model, Make and Year of the Coach plus some information on What Model leveling system is installed in the coach will help the members offer some relevant information to your question. Rich. Share this post Link to post Share on other sites
keithl Report post Posted July 24, 2019 2009 Damon essence diesel with lippert Hydraulic leveling system Share this post Link to post Share on other sites
manholt Report post Posted July 25, 2019 The obvious question first. Have you checked for full hydraulic fluid in tank with all Jacks up? How often do you clean each shaft, with jacks extended? Have you called Lippert Tech? Share this post Link to post Share on other sites
keithl Report post Posted July 26, 2019 Yes to all cleaned full fluid learned that mistake once lippert hasn’t been able to help I might try redoing the calibration I did replace the batteries might need that one more item to try anyway Share this post Link to post Share on other sites
manholt Report post Posted July 26, 2019 On the web, under Lippert Jacks, there is an article on how to re-set your computer...it goes against the Lippert re-set info., very easy to understand...I had a stuck Jack. re-set and no problem since. I have Jacks and Air, Auto & Manual...easy to get a fault or twist code, then nothing works, until computer thinks it's level. Share this post Link to post Share on other sites
wayne77590 Report post Posted July 26, 2019 For the LCI Level Up Motorhome Leveling (2013-Present) Owner's Manual, it states: Level Zero Point Calibration Before auto leveling features are available, the Level Zero point must be set. This is the point to which the system will return when an auto leveling cycle is initiated. To set the zero point (controller module must be fully secured in production-intent location), first run a manual leveling sequence to get the vehicle to the desired level point. Then activate the Level Zero point configuration mode. This mode is enabled by performing the following sequence: 1. Turn panel off. 2. Press the Front switch 10 times (On Winnebago units, press FRONT 5 times). 3. Press the Rear switch 10 times (On Winnebago units, press REAR 5 times). 4. At this point, a tone will sound and the display will read ZERO POINT CALIBRATION. 5. Press ENTER to set the zero point. 6. Screen will then display Zero Point Stability Check and PLEASE WAIT. 7. Tone will sound and the screen will display ZERO POINT SUCCESSFUL. 8. Control will then turn off. Share this post Link to post Share on other sites
keithl Report post Posted July 28, 2019 So far so good on leveling I did re-lube shafts and re-calibration I have 2 more stops this week hopefully all continues to work keith Share this post Link to post Share on other sites
manholt Report post Posted July 28, 2019 We wish you luck! Safe travels... Share this post Link to post Share on other sites
