mmaurice Report post Posted September 19, 2022 I have a Fleetwood Southwind and the dash is horrendous. It shakes and rattles so bad that the radio actually fell into the dash. I have heard this is a very common problem with Fleetwood. If anyone has any tips, pointers ideas on how to fix and where to start, it would be greatly appreciated. Share this post Link to post Share on other sites
farmerdave595 Report post Posted September 27, 2022 We have a Fleetwood flair and have dash shakes and when were driving the passenger side has air blowing into it while driving. To improve the shaking, we found bolts missing or loose holding the frame to the dash under the hood. I would replace it and a few hundred miles down the road it was gone again. my repair shop added a third bolt and later on I used loctight around the bolts to hold them in place. Share this post Link to post Share on other sites
wildebill308 Report post Posted September 29, 2022 On 9/26/2022 at 9:58 PM, farmerdave595 said: We have a Fleetwood flair and have dash shakes and when were driving the passenger side has air blowing into it while driving. To improve the shaking, we found bolts missing or loose holding the frame to the dash under the hood. I would replace it and a few hundred miles down the road it was gone again. my repair shop added a third bolt and later on I used loctight around the bolts to hold them in place. Are you using bolts or screws? If bolts what nuts are you using? Bill Share this post Link to post Share on other sites
james681 Report post Posted October 30, 2022 I had the same problem with my Southwind. The dash is mounted on brackets that extend frm the front of the coach, not attached very well on the sides, Simple fix, cut a 1x4 oard the length from the floor to the mountng bracket and wedge it in against the wall. Works great and costs nothing Share this post Link to post Share on other sites
mmaurice Report post Posted November 27, 2022 On 10/30/2022 at 4:08 PM, james681 said: I had the same problem with my Southwind. The dash is mounted on brackets that extend frm the front of the coach, not attached very well on the sides, Simple fix, cut a 1x4 oard the length from the floor to the mountng bracket and wedge it in against the wall. Works great and costs nothing Any chance you have a picture of where you placed these boards? Share this post Link to post Share on other sites