bm02tj
-
Content Count
375 -
Joined
-
Last visited
Posts posted by bm02tj
-
-
The best is talk to your agent
-
The October mag has order info I think page 6
Email awhite@fmca.com
Bruce
-
Oct issue page 6
If bad oval contact Aaron White
I Email and asked for a picture so I could decide if it was good enough to order one as I never bothered to install the original one sent to me
-
If you used that much water in 3 to 4 months check your charging voltage
-
22.5 tires
in Tires
I am on second set of HRS's replace first ones at 8 years old no cracks
Never had the other brand so cannot comment
I understand Michelin do not fair as well
-
Every one seems to have faults so it is hit and miss
Pick the most important items and ask each one and hope they live up to there claim
-
13 ft 2 in I have label on speedo with both metric and feet
-
Is problem on 120 or propane or both
-
-
That sounds to high what is your hot idle pressure at
-
How is your oil pressure when this happens as you will have a Heui system
and depends on good oil
-
My self I would go with the Continentals as Michelin has slid down the quality line
-
I looked and said no way
-
Good to see someone is paying attention and fixing items right away
They seem to have learned ignoring a problem only makes it worse
-
Age alone is part of it
You should always ask for the old parts so you can see why they are changed then let them dispose
You would likely see rust pock marks in the rotors and metallic brake pads rust and break down
With that low of mileage add some good additive's and change the oil early as age is a killer
-
If you are on a 30 amp that is 125 not 220 so L1and L2 tied together
-
The battery bank should be connected to alternator via a solenoid that is engaged when in run mode
-
On 6/18/2021 at 8:37 AM, rayin said:Generac makes an automatic transfer switch for exactly this application: GenerLink MA23-N - City Plumbing & Electric (cpesupply.com)
To everyone else:
There is no excuse for not having a transfer switch, here's one for only $63: PowerMax PMTS-30 Automatic Transfer Switch | Northern Arizona Wind & Sun (solar-electric.com)
To do it correctly it has to carry the total load so with my house 200amp
or you need to add second panel with all the circuits you want to supply power to with a breaker in main panel to ATS then second panel
-
Does physically count
-
To do the job with auto change over
needs all above plus a second breaker panel to feed the circuits that are to be fed by the generator with 100 amp two pole breaker in main panel to feed transfer switch
and new panel as most of your home needs to be isolated from generator
-
The ground and the neutral are connected to the body of the breaker panel so joined so the neutral is not completely disconnected with an ATS
-
We just had power grid upgrades and power off Saturday 9am to 5pm
then Sunday 9am to 3pm
I turned all my breakers off including main
ran patch cord to the range plug I have in the garage
tied both legs together and only turned on what I needed paying attention to the fact I am using a 10gauge cord
so fridge freezer and coffee
-
When we park in Moab for a month we have a bed in the garage
I think it would not be good to full time in
Bruce
-
Old is new 🥵😸
septic toilet paper
in General Discussion
Posted · Edited by bm02tj · Report reply
Test your TP put in a jar with a little water and give a shake if it falls apart easily it is ok
I tested Kirkland and it passed so that is what we use