raibourn Report post Posted August 24, 2018 I am considering having my holding tanks cleaned by a company named Kleen Tank Service, but before I spend the money would like to know if anyone has any experience with this company and if so, what were the results? Thanks Share this post Link to post Share on other sites
richard5933 Report post Posted August 24, 2018 Welcome to the forum. Just curious what the reason would be to have your tanks cleaned like that? Is there a problem or just routine maintenance? Share this post Link to post Share on other sites
raibourn Report post Posted August 24, 2018 They will be at the Thor Diesel Club rally and ae offering a "special" so it looked like a good time to consider this service. I do not have a significant problem, so mostly routine maintenance, but I am hoping that the gauges will be more accurate. I know that is probably just a dream! Share this post Link to post Share on other sites
desertdeals69 Report post Posted August 24, 2018 If you have lights they will never be accurate because of the internal contacts. If you want more accurate you need a system like See Level with external sensors. Share this post Link to post Share on other sites
hermanmullins Report post Posted August 24, 2018 I installed Sea Level gauges after Perry last year and couldn't be happier with them. While at Perry i bought them and the President of Sea Level asked what coach I had. I told him and he drew the complete diagram for me to do the installation completely from memory. Worked like a charm. Herman Share this post Link to post Share on other sites
rossboyer Report post Posted August 24, 2018 I have installed SeaLevel II on two different coaches. Best system available. My control panel is in the bathroom. That was the best location to get to 12 vdc and access to below the floor and tanks. Just followed water lines. I used new wire which left the old idiot lights active, but you can use the old wire, also. Share this post Link to post Share on other sites
desertdeals69 Report post Posted August 24, 2018 I used the original wires and mounted the monitor next to the control panel. My original system was not working right. Share this post Link to post Share on other sites
