donaldrfiske Report post Posted January 16, 2019 Ignition in acc mode jacks are up and power button is on jack down light is on and jacks won’t extend in auto mode but will manually any suggestions how to correct this problem Share this post Link to post Share on other sites
ianbullock Report post Posted January 16, 2019 Couple of questions. MH running, Ignition on? Parking brake on? Share this post Link to post Share on other sites
manholt Report post Posted January 16, 2019 Do you have a DP coach or gasser. If DP the air needs to be dumped first, if gas, I don't know! Share this post Link to post Share on other sites
donaldrfiske Report post Posted January 17, 2019 Dp coach air drained down ignition in acc position turn on power to levellers and jack down light is on I physically checked and jacks are up it will let me manually drop down the jacks was wondering if maybe the the system needs to somehow be reset Share this post Link to post Share on other sites
donaldrfiske Report post Posted January 17, 2019 Also the air break is on Share this post Link to post Share on other sites
wayne77590 Report post Posted January 17, 2019 press and hold the enter button and the retract button at the same time for over 5 seconds and see what happens. Share this post Link to post Share on other sites
donaldrfiske Report post Posted January 17, 2019 Will do tomorrow thanks Share this post Link to post Share on other sites
hermanmullins Report post Posted January 17, 2019 Donald, how is the fluid level? Herman Share this post Link to post Share on other sites
donaldrfiske Report post Posted January 17, 2019 Will check that also thanks ......sooo topped off fluid level and ran jacke through a few cycles and the jack down light went off!!! Thanks to all who responded Share this post Link to post Share on other sites
donaldrfiske Report post Posted January 24, 2019 So guys is it best to check hyd fluid level on DP with jacks in the up stored position or when they are down stabilising the coach Share this post Link to post Share on other sites
wildebill308 Report post Posted January 24, 2019 In the up/stored position. Bill Share this post Link to post Share on other sites
hermanmullins Report post Posted January 27, 2019 Some say to lower the jacks about 4 inches and then check the level. That method to me might over fill the unit. Might I suggest that you contact the maker of your jacks and ask them. Good luck. Herman Share this post Link to post Share on other sites
donaldrfiske Report post Posted January 27, 2019 Thanks guys I'll check the level in the up position and also research the manufactor Share this post Link to post Share on other sites
