randylinda875 Report post Posted April 25, 2021 I have a Norcold N822RT that is warming up. My research says it is the thermistor. Does anyone have a YouTube on the replacement of that item? Share this post Link to post Share on other sites
txiceman Report post Posted April 25, 2021 Last Thermistor I changed in a Norcold was just a matter of shutting off the power to the fridge, remove the old one and plug in the new one and clip it into place.. Ken Share this post Link to post Share on other sites
wayne77590 Report post Posted April 25, 2021 (edited) What Ken said. Mark where the present one is and start from there. It slides up and down for warmer/colder (don't remember which way for one or the other). Sometimes those things have a way of getting bumped or vibrated and slid. Try moving it to the location where it is to be colder and see what happens. Ken, is it up or down for colder? Edited April 25, 2021 by wayne77590 Share this post Link to post Share on other sites
rossboyer Report post Posted April 25, 2021 Up Colder, Down Warmer Share this post Link to post Share on other sites
wildebill308 Report post Posted April 25, 2021 On 4/25/2021 at 12:27 PM, randylinda875 said: I have a Norcold N822RT that is warming up. My research says it is the thermistor. Does anyone have a YouTube on the replacement of that item? Looks like it has been well covered. Just want to say welcome to the forum. Bill Share this post Link to post Share on other sites
txiceman Report post Posted April 25, 2021 On 4/25/2021 at 2:13 PM, wayne77590 said: What Ken said. Mark where the present one is and start from there. It slides up and down for warmer/colder (don't remember which way for one or the other). Sometimes those things have a way of getting bumped or vibrated and slid. Try moving it to the location where it is to be colder and see what happens. Ken, is it up or down for colder? I have had a residential too long and don't remember. But one fin to the left is colder. Ken Share this post Link to post Share on other sites
rossboyer Report post Posted April 25, 2021 That works, also. More change than sliding up or down on same fin. Share this post Link to post Share on other sites
dons2346 Report post Posted April 26, 2021 Thermistors usually don't go bad unless they get damaged. Try adjusting before changing it out. Share this post Link to post Share on other sites
randylinda875 Report post Posted April 27, 2021 Thank you for your help I will try some of those suggestions. Share this post Link to post Share on other sites
randylinda875 Report post Posted April 27, 2021 The clip holding the thermistor is very rusty. Should I replace that or is it permanently attached to the thermistor? Share this post Link to post Share on other sites
wildebill308 Report post Posted April 27, 2021 On 4/27/2021 at 8:54 PM, rayin said: The clip is a spring-tension fit, simply pull it off the fin and clean off the corrosion with fine emory-paper so it makes goon contact to transmit temperature. Ray that is great advise it probably should be part of annual maintence just so you have a good contact. Bill Share this post Link to post Share on other sites
