Polmex Report post Posted June 18 Gonna change belt on my generac 7500 watt on my 2005 Alfa founder. Unit does not slide out. Any helpful hints would be apreciated regarding access.etc Share this post Link to post Share on other sites
wildebill308 Report post Posted June 19 On 6/18/2022 at 1:10 PM, Polmex said: Gonna change belt on my generac 7500 watt on my 2005 Alfa founder. Unit does not slide out. Any helpful hints would be apreciated regarding access.etc I would lookup a service manual for that model. Have you looked on You tube? Share this post Link to post Share on other sites
jleamont Report post Posted June 20 Remove the cover on the back. The awkward part, there’s no adjustments or tensioner. I removed the water pump pulley, removed old belt, put the new belt on, forced the pulley with the belt onto the water pump by hand, started the screws by hand, snugged with a cordless impact gun, torqued with a torque wrench. It wasn’t bad, but ours is on a slide and comes out very far. Share this post Link to post Share on other sites
Polmex Report post Posted June 26 Thank you for the responses. I tried but could not get entjre side off and dont have room to get un there. Im gonna take it to our shop and have other gen techs help me. Were gonna pull it out and do a complete level 3 service on it. Thanks again Share this post Link to post Share on other sites