dontayman001 Report post Posted June 3, 2022 Looking for the air line desicate filter, fleetwood told me it was on the drivers side just past rear axle. If so it must be in Stealth mode.. Any ideas ??? Share this post Link to post Share on other sites
five Report post Posted June 4, 2022 (edited) It would be lots easier to help if you added your coach, it's year, make, model, equipment, toad, etc, to your signature. Telling us it's a "Fleetwood" is not much help!😆 Edited June 4, 2022 by five Share this post Link to post Share on other sites
rossboyer Report post Posted June 4, 2022 I think you will find it in front of the rear axle. Follow the airlines to find it. I have found that it is difficult to replace, and Fleetwood used two different manufacturers. So remove it before buying a replacement. Share this post Link to post Share on other sites
dontayman001 Report post Posted June 5, 2022 Frieghtliner XC ,2007 diesel pusher, Bounder 35H.. Just looking for air filter.............. Share this post Link to post Share on other sites
jleamont Report post Posted June 5, 2022 That vintage XC, usually they are behind the rear axle drives side. The last one I worked on was a 2006. Share this post Link to post Share on other sites
wildebill308 Report post Posted June 5, 2022 11 hours ago, dontayman001 said: Frieghtliner XC ,2007 diesel pusher, Bounder 35H.. Just looking for air filter.............. Just find the air intake and follow the air duct. It is a BIG cylinder and you replace the whole assembly. You could start from the outher end to start at the turbo and work back to the air cleaner. While you are doing this make shure all the clamps are tight. Bill Share this post Link to post Share on other sites
rossboyer Report post Posted June 5, 2022 There is a big difference between the engine air intake filter and the desiccate air dryer for the air brakes. Share this post Link to post Share on other sites
rayin Report post Posted June 5, 2022 (edited) Depending on mfgr. it will look like one of these. I would assume it is either a Wabco, Haldex or Bendix brand. The most important thing to remember is block under the frame and bleed away ALL air pressure before beginning to remove the filter, next important is cleanliness, any tiny bits of dirt allowed into the main dryer housing can cause problems after reassembly. Clean away all road grime and dirt before trying to remove the desiccant filter. Since it is a 2007 and evidently never been serviced, I recommend buying the entire rebuild kit, it contains items to rebuild all the valves in the dryer assembly (4), plus the filter cartridge. Edited June 5, 2022 by rayin Share this post Link to post Share on other sites
