jpmihalk Report post Posted July 9, 2017 8 hours ago, rfsod48 said: I installed a set of snap pads and have used them on gravel for 1 month and at the Diesel rally this passed week on grass. So far they seem to work great and there is no placing and storage once installed. We also installed a set of Snap Pads and they have worked great on gravel, grass, concrete and asphalt. It is great to not have to get down on the ground every time to set out pads or blocks to level on, especially when the weather outside is less than perfect. Share this post Link to post Share on other sites
fagnaml Report post Posted July 12, 2017 Carl brings up a good point. My Damon Astoria has a GVWR of 28,000 lbs and the Lynx blocks work well. They may not work so well for very heavy motorhomes. I can not find a max weight rating for the Lynx blocks. However, I have an older, partial set of Valterra leveling blocks that I used with my travel trailer for 18 months of temporary living while on a project assignment (disposed of several of them after the became fatigued by the sun). Valterra blocks have a max weight rating of 40,000 lbs. I'd think Lynx and other brand blocks would have a similar max weight rating. Valterra leveling blocks info --> https://www.rvupgradestore.com/EZ-LEVELER-JACK-PAD-p/92-0918.htm Share this post Link to post Share on other sites
donaldrfiske Report post Posted April 30, 2018 So I've been using pressure treated 4x4 18 inches long on all for pads works great for me Share this post Link to post Share on other sites
wildebill308 Report post Posted April 30, 2018 1 hour ago, donaldrfiske said: So I've been using pressure treated 4x4 18 inches long on all for pads works great for me Welcome to the forum. I was doing that and it works on hard/flat surfaces. The problem is they will split when on grass or dirt or just uneven surface. Look on page one at the post I made showing the "upgraded" pads. These have worked well and no more split boards. Bill Share this post Link to post Share on other sites
TimeTraveler Report post Posted May 4, 2018 We have 12x18 with plywood screwed to them. Where we store it, the Mgr put some eyes on them and we use the rod to awnings to push them in and pull them out. Wish they were larger but the tires get in the way in the rear. I believe I can make them about four inches longer and juts fit in that rear compartment, that seems made for them. Some of the RV Parks, in Michigan, the ground is so soft we have to readjust the jacks it seems every morning. Left the Coach at Relatives home there, for a emergency trip back home. Came back the boards and jacks were eight to ten inches deep. I've busted a bunch of these wood jack pads from soft soil etc. The big pads mnc blueford talks about sounds good. I saw some pads on a big truck used on power lines. They were 140.00 each. Don't remember the size but huge. Looks like the only way to go is the tough and hard plastics and longer than wider. These things we made, weigh I suspect 40 lbs or so. That is hard to shove under the coach, and to dig out of the mud. In Texas hill country just west, of Austin, in an RV Resort, we woke up to jacks put down in the dark , fully extended and on the wood pads buried as deep as the jack rams were long. Ground looked dry and firm but 3 feet down water was flowing over solid stone. They brought us big pieces, of plywood and seemed like every stray piece, of lumber around, to put under the jacks and dug out our pads. The jacks said suuu thuuuunk as they came up. Share this post Link to post Share on other sites
manholt Report post Posted May 4, 2018 We are ordering from Amazon, 2 set's of Utility Blocks at $95 each. Linda needs a set for her DP, Jacks only. I want a set for those times that I can't get level by air alone and need to use my Jacks. More expensive than wood, but at 14.5 pounds for 4 and will not break at 60,000 pounds, or rot...I feel that it's cheap! The RV Geeks have been using them for 10 years now, Newmar Tag....no problems! Share this post Link to post Share on other sites
manholt Report post Posted May 4, 2018 On their way! Share this post Link to post Share on other sites
jleamont Report post Posted May 4, 2018 On 7/7/2017 at 3:17 PM, manholt said: I tried them...they don't hold up to 57,000+ pounds real well ! Neither do campground fire rings placed incorrectly , ran over one a few years ago with the DP, in 1000 years someone will dig it up and wonder what it is . I have Lynx with their chocks that interlock leftover from the old coach, only needed them once for the DP (air leveling only). I have considered pulling them out for more basement space Share this post Link to post Share on other sites
wayne77590 Report post Posted May 5, 2018 18 hours ago, manholt said: We are ordering from Amazon, 2 set's of Utility Blocks at $95 each. Linda needs a set for her DP, Jacks only. I want a set for those times that I can't get level by air alone and need to use my Jacks. More expensive than wood, but at 14.5 pounds for 4 and will not break at 60,000 pounds, or rot...I feel that it's cheap! The RV Geeks have been using them for 10 years now, Newmar Tag....no problems! A link to them please? Share this post Link to post Share on other sites
manholt Report post Posted May 5, 2018 Jim. How did you do that? Share this post Link to post Share on other sites
manholt Report post Posted May 5, 2018 Jim, you got it anytime! I'm at the ranch until the 16th. Hope your 40 rpm's have improved. Back to subject. Utility Blocks is what I had, before my Jacks quite working....now I have all new (higher PSI) Hydraulic lines & will start using them again! Specially in high wind conditions! Share this post Link to post Share on other sites
jleamont Report post Posted May 5, 2018 Jim, those pads you posted the link on look very sturdy! With a jack spreading the load would be critical in my eyes! Share this post Link to post Share on other sites
jgallego Report post Posted May 5, 2018 Carl, I just order 4. Thanks, Jaime Share this post Link to post Share on other sites
wayne77590 Report post Posted May 5, 2018 What link? I can't find the link. Sheesh! Share this post Link to post Share on other sites
manholt Report post Posted May 6, 2018 Wayne, go to Amazon, enter, heavy duty RV jack pads in search box, scroll down to Utility Blocks, right click, then scroll down to comments. Then go back to order and right click ! Share this post Link to post Share on other sites
brown774 Report post Posted June 16, 2018 Google SnapPads, they work great! Share this post Link to post Share on other sites
wayne77590 Report post Posted June 16, 2018 On 5/6/2018 at 5:44 AM, elkhartjim said: I posted the link immediately after your first request, Wayne. Scroll up....sheeesh back at you.😜 Aw, you went back and edited it, I know. Thanks. Share this post Link to post Share on other sites
manholt Report post Posted June 17, 2018 Brown. How much does your coach weigh? Share this post Link to post Share on other sites
megadiesel Report post Posted July 25, 2018 I have a local stair manufacturer that has stacks of cut offs in and around his dumpster and is happy when you take it away so he doesn't have to pay for it. It is also great Oak for fire pits! If you can get cut offs of laminated beams nothing is stronger. Share this post Link to post Share on other sites
wildebill308 Report post Posted July 26, 2018 2 hours ago, megadiesel said: I have a local stair manufacturer that has stacks of cut offs in and around his dumpster and is happy when you take it away so he doesn't have to pay for it. It is also great Oak for fire pits! If you can get cut offs of laminated beams nothing is stronger. Welcome to the forum. Unfortunately I don't have your acess so I had to make my pads. Where are you we might drop by and pick up some spares. Bill Share this post Link to post Share on other sites
dickandlois Report post Posted July 26, 2018 1 hour ago, megadiesel said: I have a local stair manufacturer that has stacks of cut offs in and around his dumpster and is happy when you take it away so he doesn't have to pay for it. It is also great Oak for fire pits! If you can get cut offs of laminated beams nothing is stronger. Sourcing items can be an issue at times, thanks for the info. Could you offer a location of the Oak - plus. Do not need to post the company name, the forum is not intended as a market place. Share this post Link to post Share on other sites
